Development of Transformer Type Reactor Ttr For Application Of Thyristor Controlled Transformer Type Reactor TCTTR

Abstract

In India, fixed Shunt Reactors are provided on 400 kV lines mainly for suppression of over voltage due to Ferranti Effect under light load / no load. At peak load these reactors continuously absorb rated reactive power and thus limit newlinesteady state power transfer capacity of the lines, reduce bus voltage during steady state peak load condition and during recovery voltage and also reduce Surge Impedance Loading (SIL) Level. The disadvantages associated with permanently connected fixed shunt reactors newlinecall for the development of a Controlled Shunt Reactor.Transformer Type Reactor (TTR) is a 3 winding transformer with 100% newlineimpedance between primary and control winding. TTR is developed for the first newline50 MVAR 400 KV Thyristor Controlled Transformer Type Reactor (TCTTR) in newlineIndia. TCTTR is different as compared to established shunt connected controllers newlineviz Thyristor Controlled Reactor (TCR) and Thyristor Switched Reactor (TSR). Some of the important differences are given below: newline.TCR and TSR are established controller under FACTS [1]. The concept of TCTTR is suggested by Prof. G.N.Alexandrov newline[2] He presented this concept during proceedings of Trafo-Tech 1994. newlineIn TCR and TSR reactor is having single winding. In TCTTR three winding transformer is used as reactor. newline. For application on 420 kV system, the voltage level of the Thyristors for newlineTCR and TSR will be same as that of transmission line i.e. 420 kV. newlineIn TCTTR the thyristors are provided on low voltage control winding. newlineThe voltage level of the thyristors is in the range of 11 to 24 kV. newlineThe TCR, TSR and TCTTR are shunt connected controllers. newline newlineThe advantages of using TTR in TCTTR in place of single winding reactor as newlineused in TCR and TSR are as follows newlineThyristors can be economically used on low voltage winding of TTR for newlinereactive power control. newlineThyristors are used to their full capacity newlineThe harmonics and other disturbances developed on low voltage side due newlineto thyristor control operations will not have any harmful effect on the EHVI newlineUHV transmission system due to 100% impe

Description

Keywords

Citation

item.page.endorsement

item.page.review

item.page.supplemented

item.page.referenced