Investigation on Multimode and Variable Gain SiGe Cascode

Abstract

WiGig, a 5G indoor wireless protocol based on IEEE 802.11ad standard operating newlinearound 60GHz frequency is gaining popularity due to its high data rate. Owing to the newlinepresence of unlicensed and underutilized spectrum around the 60GHz, IEEE 802.11ad newlineis still in the process of standardization and is increasing its band. IEEE 802.11ad newlinestandard is defined for a wide band of 14GHz and is divided into six channels (previously newlinefour), each of which has a bandspace of 2.16 GHz. High propagation and Oxygen newlineabsorption losses are some of the major issues in using this frequency band for indoor newlineshort range high data rate WiGig applications. The input signal of these systems is newlineusually very weak because of atmospheric absorption and multi-path reflections. This newlinerestriction put stringent requirement on designing RF components. Using basic RF newlinecomponents such as low noise amplifiers (LNA), down converters, oscillators, and other components, a receiver architecture is modelled in AWR Design Environment simulation newlinesoftware to meet the IEEE802.11ad standard.The main objective of this research work is to find an LNA suitable for four channelsindividually and with channel bonding in IEEE 802.11ad standard with higher performance than previously designed 60GHz LNAs. The novelty of this work lies in newlineproposing two topologies such as High frequency gm boosting and modified derivative newlinesuperposition technique to improve noise figure (NF) and linearity of the LNA. newlineIn order to comply with Phased arrays systems in 5G WiGig receivers, a Variable newlinegain LNA (VGLNA) is also proposed with less phase variations on different gain stages newlineusing Stepped Impedance Micro-strip Open Circuited Stubs (SIMOCS) with minimum newlinecontrol circuit. Post layout Electromagnetic (EM) simulation results are presented and analyzed newlinefor the suitability of the circuits in WiGig receiver. To evaluate the reliability of the proposed circuit, the designed LNAs are simulated under different process, voltage, newlineand temperature (PVT), conditions. In addition, the performance..

Description

Keywords

Citation

item.page.endorsement

item.page.review

item.page.supplemented

item.page.referenced