Experimental study on wire electrical discharge machining of al sic tic composites
Loading...
Date
item.page.authors
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
The wire electrical discharge machining process is a potential
newlinecandidate to cut any intricate shape in conductive materials (electrical
newlineresistivity lt 100 and#937;-cm) regardless of its hardness. Some of the researches
newline(Kozak et al. (2004), Mohri et al. (2002), Tani et al. (2004)) have attempted
newlineto process low conductive and insulating ceramics in WEDM process. These
newlineattempts are literally stretching the capability of the WEDM process. After,
newline2004, no good research is reported in the area of WEDM of low conductive
newlinematerials. Hence, in the present work a potential low conductive metal matrix
newlinecomposite (Al-SiC-TiC) was prepared for processing the same in the WEDM
newlineprocess.
newlineThe Al-SiC-TiC composites of various compositions namely,
newline75% Al + 20% SiC + 5% TiC ; 70% Al + 20% SiC + 10% TiC and
newline65% Al + 20% SiC + 15% TiC were prepared. The received Aluminium (Al),
newlineSilicon carbide (SiC) and Titanium carbide (TiC) powders are ball milled to
newlinereduce the particle size, powder blending and mixing operation. By using
newlineTOPSIS method the ball milling parameters are optimized. The optimal
newlineparameters are the ball size of 8 mm, milling time of 4 h, rotation speed of
newline250 rpm and ball weight ratio of 10:1. The powdered mixture was compacted
newlineto a pellet in a square die, pressurized to 8 to 9 tons, and further sintered at a
newlinetemperature of 500 °C for a duration of two hours and placed in the furnace
newline