Optimizing Reactive Power Control in Single Phase Photovoltaic System to Meet Grid Specifications

Abstract

As conventional energy sources are exhausting and are resulting in environmental problems with their usage, renewable energy sources are emerging as the preferred choice in the quest of energy worldwide. More and more countries are setting up high targets of renewables in their energy system. India is going through a transition in its solar market. The emphasis is more on large-scale grid integrated projects under Jawaharlal National Solar Mission. Studies emphasize that the major growth in solar segment which is concentrated in very selected areas in urban India. Using Solar power generated from photovoltaic, has increased several fold after the launch of the Jawaharlal National Solar Mission in 2010. Solar Photovoltaic (SPV) energy is an important energy source as it is clean and inexhaustible. newlineAs it is important to operate PV energy conversion systems at the maximum power point (MPP) to maximize the output energy of PV array, in this research a maximum power point technique (MPPT) control which is necessary to extract maximum power from the PV arrays is implemented. A comparison of two MPPT methods under a wide range of operating conditions is done. The classical method, Perturbation and Observation (PandO), was implemented and it is compared with Fuzzy Logic MPPT control (FLC). It was observed that the classical method lacked the quick adaptability when the environmental conditions like irradiations and temperature are varying. The results indicate a better performance of the proposed FLC compared to the classical Perturb and Observe method. newlineGrid synchronization techniques play an important role in the control of single- phase systems in order to fulfill the demands as per grid requirements. Thus, it is necessary to evaluate the behavior of grid synchronization method. The phase locked loop (PLL) based synchronization takes much more attention these days. A good PLL technique should be able to estimate amplitude and frequency of the grid voltage quickly. In this research T/4 delay is used. newlineCurrent grid standards for SPV systems expect it to operate at MPPT mode under normal operating conditions. But whenever grid fault occurs, it is expected tomaintain the voltage profile constant. In this research, system under stable operating conditions supplies power to the load and PV system works in MPPT mode is designed. Whenever the fault occurs at point of common coupling (PCC), the voltage reduces. The proposed controller maintains the voltage profile by injecting the current fed by current controller at PCC. The controller shifts from MPPT to faulty mode and maintains the voltage as per the grid requirements. During the islanding conditions, the SPV system successfully caters to the requirements of the load by shifting the control from MPPT to islanding mode. When SPV system is in operation the power quality is enhanced. This research presents the modeling and simulation of a single phase photovoltaic inverter that operates in islanded mode and utility-connected mode. Modeling and simulation results are given to demonstrate the ability of the developed inverter to provide advanced control functions such as power flow and reactive power control. newline

Description

Keywords

Citation

item.page.endorsement

item.page.review

item.page.supplemented

item.page.referenced