Heat Transfer Enhancement and Pressure Drop Characteristics of Laminar Flow through a Square Duct Fitted with Transverse Ribs and Helical Screw Tapes

Loading...
Thumbnail Image

Date

item.page.authors

Journal Title

Journal ISSN

Volume Title

Publisher

Abstract

newlineThe boundary layer is not limited to a thin layer in a laminar flow regime and is a challenge for newlineheat transfer enhancement. Different techniques are incorporated in industries to combat the newlinechallenge. This thesis aims to enhance the heat transfer rate at minimum frictional losses. The newlinecombination of boundary layer separators and bulk mixing devices in laminar flow can achieve newlinethe objective. newlineThe thermo-hydraulic characteristics of ribs with helical screw tape in the square duct have newlinebeen investigated. The current numerical analysis elucidates the effect of geometrical newlineparameters and fluid properties on the rate of heat transfer in the laminar flow regime. The newlinecommercial software ANSYS Fluent has been used. In the first case, the transverse ribs fitted newlineon all surfaces of the duct in synergy with helical screw tape have been analysed. The uniform newlinewall heat flux on four outer surfaces of the duct has been imposed. The effect of rib pitch, rib newlineheight, and screw tape parameter on heat transfer, and friction factor have been reported here. newlineThe Nusselt number increases with an increase in rib height. On decreasing the rib pitch and newlinescrew tape parameter, the Nusselt number decreases. The rib pitch and screw tape parameter newlineeffect are illustrated by the numerical data, obtained at constant heat duty. Also, the newlineperformance of different fluids is numerically examined. Out of different fluids, Servo-therm newlineoil performance is the best. This is attributed to the high Prandtl number, and effective newlineboundary layer separation yielding a reduction in thermal resistance. newlineIn the second section, the ribs were fitted on two surfaces (facing each other) with a helical newlinescrew tape insert at the center of a square duct. The uniform wall heat flux was applied on the newlinetwo surfaces where the ribs were fitted. The other two walls are at 300 K. The effect of rib newlineangles is elucidated in the laminar flow and has been reported in the thesis. The 45-degree newlineangle ribs with helical screw tape performance are better

Description

Keywords

Citation

item.page.endorsement

item.page.review

item.page.supplemented

item.page.referenced